Toshiba NB500 Series User Manual page 101

Problem
Battery doesn't
charge when the AC
adaptor is attached
Battery doesn't
power the computer
as long as expected
User's Manual
NB500/NB505/NB520/NB525/NB550D/NB555D Series
Procedure
If the battery is completely discharged, it will not
begin charging immediately, in these instances you
should wait a few minutes before trying again. If the
battery still does not charge, you should check that
the power outlet the AC adaptor is connected to is
supplying power - this can be tested by plugging
another appliance into it.
Check whether the battery is hot or cold to the touch
- if so, it will not charge properly and should be
allowed to reach room temperature before you try
again.
Unplug the AC adaptor and remove the battery to
make sure its connecting terminals are clean - if
necessary wipe them with a soft dry cloth lightly
dipped in alcohol.
Connect the AC adaptor and replace the battery,
taking care to ensure that it is securely seated in the
computer.
Check the DC IN/Battery indicator - if it does not
glow, allow the computer to charge the battery for at
least twenty minutes. If the DC IN/Battery indicator
starts to glow after this period, allow the battery to
continue to charge for at least another twenty
minutes before turning on the computer. However, if
the indicator still does not glow, the battery may be
at the end of its operating life and should be
replaced. However, if you do not believe the battery
is at the end of its operating life, you should speak
to your reseller, dealer or service provider.
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential - in these instances you should fully
discharge the battery and then attempt to charge it
again.
Check the Power saver option under Select a
power plan in the Power Options.
6-6