Subscribe to Our Youtube Channel
Related Manuals for Ingersoll-Rand 6L Series
Summary of Contents for Ingersoll-Rand 6L Series
- Page 1 45612736 Edition 2 May 2014 Air Drill 6L Series Maintenance Information Save These Instructions...
- Page 2 Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories •...
- Page 3 8. Remove the Bearing Seat Retainer (110) and slide off the Rear to remove the Grease Shield (46) and Spindle Bearing (48). Thrust Bearing Seat (111), Bevel Pinion Thrust (112) and Front 11. Remove the Seal Support (30) from the Spindle. Thrust Bearing Seat (113) from the pinion shaft.
- Page 4 to a depth approximately one-half the length of the Bushing. 21. Looking down the axis of the Rotor and Cylinder (25), position the Put a few drops of a quality sealant in the counterbore Cylinder over the Rotor with the cylinder dowel hole at twelve surrounding the outside diameter of the Bushing.
- Page 5 center of the Spindle Planet Gears. Make certain the teeth of the it on the Spindle to 10 ft-lb (13.5 Nm) torque. For 7L3A4 Angle Head, spread the Bevel Gear Retainer (120) and Pinion and Planet Gears mesh. For M or P ratio, grease the Rotor Pinion (37) and install it in the slip it over the end of the Spindle.
- Page 6 Minimum Dimension Maximum Dimension “A” “A” 0.718 18.25 0.728 18.50 10. Lubricate the Spindle Upper Bearing, Bevel Gear and Lower Spindle Bearing as instructed in Lubrication and install the Spindle into the Angle Head. 11. Clean the threads on the Angle Head and the Spindle Bearing Cap (121), apply a film of Vibra-Tite*** VC3 to the threads.
- Page 7 Trouble Probable Cause Solution Leaky Throttle Valve Worn Throttle Valve and/or Throttle Valve Install a new Throttle Valve and or a Throttle Seat Valve Seat. Dirt accumulation on Throttle Pour about 3 cc of a clean, suitable cleaning solution in the air inlet and operate the tool for about 30 seconds.
- Page 8 © 2014 Ingersoll Rand...
Need help?
Do you have a question about the 6L Series and is the answer not in the manual?
Questions and answers