Kioti DK90 Owner's Manual page 107

6
-12 DK90
(1) Oil Filler Plug (2) Gauge
(A) Oil Level is Acceptable Within This Range
It is located to the left of the tractor.
1. Be sure to move a drain pan under
the filter.
2. Remove the oil filter.
3. Place a film of clean transmission
fluid of the rubber seal of the new
filter.
4. Tighten the filter firmly until it con-
tacts the mounting surface. Then
tighten the filter, by hand, an addi-
tional half turn only.
5. After the new filter is in place , fill
the transmission up with oil to the
upper line of the oil gauge.
6. After running the engine for a few
minutes, stop it and check the oil
level again, add oil to the prescribed
level.
7. Make sure that the transmission fluid
doesn't leak through the seal.
S43O613A
IMPORTANT
To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine filter.
CHANGING TRANSMISSION
FLUID
(1) Drain Plug
(1) Oil Filter Catridge
S43O614A
S43O615A