Advertisement
Advertisement
Table of Contents
Related Manuals for Fillauer Motion Control MC ETD Wrist Disarticulation
Summary of Contents for Fillauer Motion Control MC ETD Wrist Disarticulation
- Page 1 MC ETD Wrist Disarticulation Prosthetist Manual...
- Page 2 MC ETD Wrist Disarticulation Prosthetist Manual Introduction The Wrist Disarticulation option provides an attachment plate that can be laminated directly to the outer socket of the prosthesis. This minimizes the length of the prosthesis in cases where much of the patient’s remnant limb has been saved.
- Page 3 Figure 2 9. Trim the excess lamination away and remove the screws and the lamination dummy. Use care in removing the last piece of plastic to prevent damage to the attachment plate. 10. Slide the O-ring over the connector and into the groove on the MC ETD (Figure 1). A small amount of silicone grease will help hold it in place.
- Page 4 Motion Control, Inc. 115 N Wright Brothers Drive Salt Lake City, UT 84116 801.326.3434 Fax 801.978.0848 www.UtahArm.com © 2019 Motion Control, Inc. 1910038 Rev F 06-25-2019 F...
Need help?
Do you have a question about the Motion Control MC ETD Wrist Disarticulation and is the answer not in the manual?
Questions and answers