Siemens SIMATIC ET 200SP Manual page 36

Article number
Encoder
Connection of signal encoders
for voltage measurement
•
for current measurement as 2-wire trans-
•
ducer
– Burden of 2-wire transmitter, max.
for current measurement as 4-wire trans-
•
ducer
Errors/accuracies
Linearity error (relative to input range), (+/-)
Temperature error (relative to input range), (+/-
)
Crosstalk between the inputs, min.
Repeat accuracy in steady state at 25 °C (rela-
tive to input range), (+/-)
Operational error limit in overall temperature ran-
ge
Voltage, relative to input range, (+/-)
•
Current, relative to input range, (+/-)
•
Basic error limit (operational limit at 25 °C)
Voltage, relative to input range, (+/-)
•
Current, relative to input range, (+/-)
•
Interference voltage suppression for f = n x (f1 +/-
1 %), f1 = interference frequency
Common mode voltage, max.
•
Common mode interference, min.
•
Isochronous mode
Isochronous operation (application synchro-
nized up to terminal)
Filtering and processing time (TCI), min.
Bus cycle time (TDP), min.
Interrupts/diagnostics/status information
Alarms
Diagnostic alarm
•
Limit value alarm
•
Analog input module AI 2xU/I 2-/4-wire HS (6ES7134-6HB00-0DA1)
Manual, 09/2018, A5E03576060-AF
6ES7134-6HB00-0DA1
Yes
Yes
650 Ω
Yes
0.03 %
0.01 %/K
-50 dB
0.1 %
0.3 %
0.3 %
0.2 %
0.2 %
35 V
90 dB
Yes
80 µs
125 µs; Starting from firmware Version V2.0.1
Yes
Yes; two upper and two lower limit values in each
case
Technical specifications
6.1 Technical specifications
35