Table of Contents
Advertisement
English
BATTERY REMOVAL/INSTALLATION
1.
Battery removal
Hold the handle tightly and push the battery
latch to remove the battery (See Fig.1 and 2).
CAUTION
Never short-circuit the battery.
2.
Battery installation
Insert the battery while observing its
polarities (See Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1.
Insert the battery in the charger.
Position the battery so that the nameplate
faces toward the ventilation slots of the
charger and press in the battery until it
comes into contact with the bottom plate.
(See Figs. 1 and 3)
2.
Connect the charger power cord to the
receptacle.
Connecting the power cord will turn on the
charger (the pilot lamp lights).
CAUTION
If the pilot lamp does not light, pull out the power cord from the receptacle and
check the battery mounting condition.
About 1 hour is required to fully charge the battery at a temperature of about 20°C. The pilot
lamp goes off to indicate that the battery is fully charged.
CAUTION
If the battery is heated due to direct sunlight, etc., just after operation, the charger
pilot lamp may not light. At that time cool the battery fi rst, then start charging.
Handle
Insert
Pull out
Rechargeable
battery
Pilot lamp
Hole for connecting the
rechargeable battery
18
Latch
Rechargeable
battery
Fig. 1
Latch
Fig. 2
Insert
Rechargeable
battery
Fig. 3
Push
Advertisement
Chapters
Table of Contents
