Standard Accessories; Battery Removal/Installation - Hitachi DN 12DY Handling Instructions Manual

English
10. Do not insert object into the air ventilation slots
of the charger.
Inserting metal objects or inflammables into the
charger air ventilation slots will result in electrical
shock hazard or damaged charger.
11. When mounting a bit into the keyless chuck, tighten
the sleeve adequately. If the sleeve is not tight,
the bit may slip or fall out, causing injury.
SPECIFICATIONS
POWER TOOL
Model
No-load speed
Drilling
Capacity
Driving
Rechargeable battery
Weight
CHARGER
Model
Charging voltage 7.2 – 14.4V
Weight

STANDARD ACCESSORIES

1 Plus driver bit (No. 2) ............................................. 1
2 Charger (UC14YF2 or UC24YFA) ............................ 1
3 Plastic case ................................................................. 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
Battery (EB1220BL, EB1230HL)
Optional accessories are subject to change without
notice.
APPLICATIONS
Driving and removing of wood screws, tapping
screws, etc.
Drilling of various metals.
Drilling of various woods.
4
Wood
(Thickness 18 mm)
Metal
(Thickness 1.6 mm)
Wood screw
UC14YF2 UC24YFA
7.2 – 24V
1.3 kg 0.6 kg
12. Do not wear gloves made of stuff liable to roll
up such as cotton, wool, cloth or string, etc.
13. Do not insert object into the air ventilation slots
of the body.
DN12DY
0 – 800 min
18 mm
Steel: 10 mm,
Aluminum: 10 mm
5.1 mm (diameter) × 40 mm (length)
EB1220BL: Ni-Cd battery, 12 V (2.0 Ah, 10 celles)
EB1230HL: Ni-MH battery, 12 V (3.0 Ah, 10 celles)
1.4 kg

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the Angle Drill, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Insert the battery firmly, in the direction shown in
Fig. 3, until it contacts the bottom of the charger
compartment.
CAUTION
If the batteries are inserted the wrong way, not only
won't they recharge, but they may damage the
charger by blowing the fuse or deforming the
terminals.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.
–1