TP-Link EAP110 Installation Manual page 7

1
If your Ethernet cable feeds through the wall,
you can position the mounting bracket to make
the cable through the fixing hole� Mark three
positions for the screw holes and then drill three
6mm diameter holes at the marked positions�
2
Insert the plastic wall anchors into the 6mm
diameter holes�
3
Secure the mounting bracket to the wall by
driving the self-tapping screws into the anchors�
Make sure that the shoulders of the mounting
bracket are on the outside�
4
Connect the Ethernet cable to the ETHERNET
port on the EAP/CAP�
5
Attach the EAP/CAP to the mounting bracket by
aligning the arrow mark on the EAP/CAP with the
arrow mark on the mounting bracket, then rotate
the EAP/CAP until it is locked into place�
English
X3
5