Power Module Status Led; Mode Led; Management Ethernet Port Led - H3C S6520X-EI Series Installation Manual

Table 8-16 System status LED description
LED mark
SYS

Power module status LED

The switch provides two power module slots on the rear panel. The power status LEDs PWR1 and
PWR2 on the front panel show the operating status of power module 1 (PWR1) and power module 2
(PWR2), respectively.
Table 8-17 Power module status LED description
LED mark
PWR1/PWR2

MODE LED

To show more information about the switch through the port LEDs, the switch provides a MODE LED
(MODE) to indicate the type of information that the port status LEDs are showing.
You can use the mode button to change the indication of the MODE LED.
Table 8-18 Description for the mode LED
LED mark
MODE

Management Ethernet port LED

Table 8-19 Management Ethernet port LED description
Management Ethernet port LED (ACT/LINK) status
Steady green
Flashing yellow
Off
Status
Steady green
Flashing green (1 Hz)
Steady red
Off
Status Description
A power module is installed in the power module slot, and the power
Steady green
module is outputting power correctly.
A power module is installed in the power module slot, but the power
Steady yellow
module has failed or no power is input to the power module.
Off No power module is installed in the power module slot.
Status Description
Steady green The port status LEDs indicate port rates.
The port status LEDs indicates the IRF member ID of the switch. For
Steady yellow example, if the LEDs for ports 1 to 5 are steady green and the other
LEDs are off, the IRF member ID of the switch is 5.
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
The switch has failed the POST or is faulty.
The switch is powered off.
Description
A link is present on the port.
The port is sending or receiving data.
No link is present on the port.
8-12