Brew Group - Saeco 10003229 Operating Instructions Manual

• Do not wash any of its parts in the
dishwasher.
• Do not use alcohol, solvents, and/or
abrasive objects to clean the machine.
• Use a soft, dampened cloth to clean the
machine.
• Do not dry the machine and/or its
components using a microwave and/
or standard oven.
After brewing milk beve-
rages, dispense hot water
from the hot water / steam wand
(Pannarello, if supplied) to obtain a
thorough cleaning.
• Every day, after heating the milk, remo-
ve the external part of the Pannarello
(if supplied) and wash it with fresh
drinking water.
• Clean the hot water / steam wand we-
ekly. In order to do this, perform the
following operations:
- Remove the external part of the
Pannarello (for standard cleaning);
- Remove the upper part of the Panna-
rello from the wand;
- Wash the upper part of the Pannarel-
lo with fresh drinking water;
- Wash the wand with a wet cloth and
remove any milk residue;
- Replace the upper part in the wand
(make sure it is completely inser-
ted).
Reassemble the external part of the
Pannarello.
• It is recommended to clean the water
tank daily:
- Remove the small white fi lter from
the water tank and wash it under
running drinking water.
- Reposition the small white fi lter in
its housing by gently pressing and
turning it at the same time.
- Fill the water tank with fresh drinking
water.
• Empty and clean the drip tray daily.
Perform this operation also when the
fl oat is raised.
• 24 •

Brew Group

• The brew group should be cleaned
• Turn off the machine by pressing the
• Remove the dregdrawer. Open the
• To remove the brew group, pull it by the
• Wash the brew group with lukewarm
• Thoroughly wash and dry all the parts
• Thoroughly clean the inside of the
• Make sure that the two reference marks
• Make sure that the lever is in contact
brewing cycles. The brew group
lubricant may be purchased through
Saeco or authorized service centers.
• Lubricate the brew group guides using
• Apply the lubricant evenly on both side
• Insert the brew group in its seat until it
• Insert the dregdrawer. Close the service
every time the coff ee bean hopper is
fi lled or at least once a week.
ON/OFF button and remove the plug
from the socket.
service door.
handle and press the «PUSH» button.
The brew group must be washed only
with lukewarm water with no deter-
gent/soap.
water, carefully clean the upper fi lter
and dry.
of the brew group.
machine.
match up.
with the brew group. Press the "PUSH"
button to make sure that the brew
group is in the correct position.
Lubricate the brew group
after approximately 500
the supplied lubricant only.
guides.
locks into place WITHOUT pressing the
"PUSH" button.
door.