Table of Contents
Advertisement
IPC/NETIPCFW-1A: User Documentation
DOC/NETIPCFW-E; V3.0
1 Introduction
1.1.
Content of this Documentation and Additional Literature
This document describes the basic firmware available for the CUB/NETIPC and IPC/NETIPC
processor boards. The firmware is partly already loaded in the Flash-Memory of the NETIPC
board when delivered and partly contained in the firmware distribution file NETIPCFW.EXE.
Please not that IPC/NETIPCFW-1A is absolutely required before you can download or modify
firmware or applications program (Note: IPC/NETIPCFW-1A is not automatically delivered
with each NETIPC board, but must be downloaded from the internet (www.syslogic.ch).
The content is based on the following program versions:
Firmware package (IPC/NETIPCFW-1A)
Boot Loader program
Embedded BIOS
Embedded DOS-ROM
All the hardware information is contained in separate manuals for each NETIPC board.
Programming information and programming examples are contained in IPC/IOCOMSW-1A
and described in DOC/IPC_IOCOMSW. For CUB/NETIPC boards see CUB/IOCOMSW-1A
and DOC/IOCOMSW.
1.2.
Items delivered
The order code IPC/NETIPCFW-1A includes the basic firmware and utilities for the
CUB/NETIPC
and
IPC/NETIPC
(NETIPCFW.EXE).
1.3.
System Requirements
The NETIPC firmware requires a PC/AT compatible computer hardware with at least a 80486-
DX processor and a Windows 95/98/NT/2000 operating system with the latest service packs
installed. In the current release most development tools run on DOS or in a Windows DOS box
or have a DOS counterpart, but the installation requires a Windows operating system.
Syslogic recommends Windows NT 4.0 (service pack 6) or Windows 2000 with a FAT file
system partitioned drive C: as a stable development platform.
1.4.
Installation
The installation program NETIPCFW.EXE contains a number of files, which must be installed
on your PC before you can work with the NETIPC board. For the installation please proceed as
follows:
1. Start up Windows on your host PC.
2. Deinstall any earlier version of NETIPCFW
3. Start the installation program NETIPCFW.EXE with a double click.
4. Print and read the instructions and comments in the README.TXT file created
in the installation directory (e.g. C:\FBCUBE\NETIPCFW).
© Syslogic Datentechnik AG, CH-5400 Baden, Switzerland, http://www.syslogic.ch
Version 3.0
Version 2.5x
Version 4.1.4 and 5.3.0
Version 4.042
boards
in
a
Windows
installation
program
6
45
/
Advertisement
Table of Contents
Need help?
Do you have a question about the IPC/NETIPCFW-1A and is the answer not in the manual?