syslogic IPC/NETIPCFW-1A User Documentation page 40

IPC/NETIPCFW-1A: User Documentation
DOC/NETIPCFW-E; V3.0
3. Download the new BIOS and bootable ROM-drive into the target:
– Connect the target COM1 port via a Null-Modem cable to the COMx-port of
your host-PC (x = port number)
Run the NETIPC boot loader program
–
– Power-on the target in the boot-load mode (see DOC/IPC_NETIPC)
Enter INITx after the boot loader program prompt (x = host-PC COM port
–
number)
– Wait for connection to target (Message „Target connected at .....")
– Enter EBIOS (or EBIOSX) to download the new Embedded BIOS
Wait for error-free completion (Note: takes several seconds, do never
–
interrupt !)
– Enter NDRIVE_X download the bootable ROM-drive A:
Wait for error-free completion (Note: takes several minutes, do never
–
interrupt !)
– Enter QUIT to automatically update the flash-tables and leave the boot loader
program
Wait for error-free completion (Note: takes several seconds, do never
–
interrupt !)
5. Start Up the target:
– Reset and Start Up the target in RUN-mode
The Linux operating system is now installed on the target. Please remember that you need a
valid run-time license (not available from Syslogic).
Use MAKEDRV2.BAT instead of MAKEDRVX.BAT and NDRIVE_2 instead of NDRIVE_X
for a 1.44 MByte ROM-Drive. See also chapter 4.4 for more information about generating a
704 kbyte or 1.44 Mbyte ROM-Disk image.
© Syslogic Datentechnik AG, CH-5400 Baden, Switzerland, http://www.syslogic.ch
40 45
/