Physical System Protection Requirements; Regulatory Standards; Installing The Server In The Rack - HP ProLiant DL360p G8 Manual

Installing the HP DL360p G8 Server

Physical system protection requirements

To properly ventilate the system, you must provide at least 7.6 cm (3.0 in) of clearance at the front
and back of the server.
Note:
It is the customer's responsibility to ensure that no environmental hazards (i.e. excessive
heat, excessive humidity, or improper ventilation) or electromagnetic interference from
proximate equipment interfere with the operation of the server.

Regulatory standards

The HP ProLiant DL360p G8 server conforms to the following standards:
EMC:
• CISPR 22:2005 + A1:2005 Class A
• EN 55022:2006 + A1:2007 Class A
• EN 55024:1998 + A1:2001 + A2:2003
• EN 61000-3-2:2006 + A1:2009 + A2:2009
• EN 61000-3-3:2008
Safety:
• EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011
• IEC 60950-1:2005 + A1:2009
• EN 62479:2010
CE:
• EN 50581:2012
• Low Voltage Directive 2006/95/EC
• EMC Directive 2004/108/EC
The product herewith complies with the requirements of the Low Voltage Directive 2006/95/EC, the
EMC Directive 2004/108/EC, the RoHS Directive 2011/65/EU and carries the CE marking
accordingly.

Installing the server in the rack

This installation checklist contains the principle steps that are necessary to install the server in the
rack. The notation in the Reference column is a section in the appropriate HP document that
Installing the HP ProLiant DL360p G8 Server
12
Comments on this document? infodev@avaya.com
September 2013