Table of Contents
Advertisement
Valve Operation
There are 3 control dials inside your Shower Cabin. These dials
control the output functions, water fl ow and temperature of your
shower.
The top dial can be turned to allow you to choose which output
you wish to use: Body Jets, Overhead (Monsoon) Shower and Hand
Shower. Turn the dial to the required output, there will be an audible
click as the selection is made. Do not turn the dial when water is
fl owing as this will decrease the life of the selector mechanism.
The middle dial adjusts the water fl ow rate. The dial rotates though
90 degrees. This dial also acts as the on/off for water fl ow.
The lower dial controls the temperature. The dial rotates from 20
degrees to 38 degrees and then will stop. This is a safety feature. To
enable temperatures higher than 38 degrees, simply press the knob
on the dial in (toward the main dial) and then turn the dial past the
38 degree mark.
Turning the temperature dial past 30 degrees MUST be done with
care to prevent scaling.
Safety Precautions
On models fi tted with Steam functions, it is normal for the steam generator to get quite hot during use.
Please allow up to half an hour for the generator to cool before touching associated areas including the
steam pod.
Always disconnect or isolate the water supply to the shower before commencing any investigations,
service or replacement of parts. Where the product has electrical power, this should also be turned
off .
Children should NOT use the shower unless under strict adult supervision.
All products are single person occupancy unless otherwise sold as twin person.
The tray surface inside the product can become slippery especially if soap, gel or shampoo is on the
surface, we therefore advise care when stepping in, out and during use.
27
Advertisement
Table of Contents
