Vidalux Hydro Plus Series Installation And Operating Manual page 14

INSTALLING THE FIXED SIDE GLASS PANELS
Locate the two fi xed glass panels. These are
diff erent from the doors as they do NOT have any holes pre-
drilled.
Now position this glass panel up to the frame pushing the long
edge of the glass into the upright of the frame until FULLY
bedded into the frame upright.
Locate the roll of Insert rubber seal.
Cutting to size, take the insert seal and push fi t on the inside of
the shower down the long edge between the fi xed glass and
framework. Trim any excess leaving it running the full length.
Ensure the trim iis tight to the bottom
This MUST be done from the inside of the frame. The glass will sit
within a lip on the inner surface of the curved rail both top and
bottom.
DO NOT HIT GLASS WITH HARD
OBJECTS TO PUSH INTO THE FRAME.
Now both glass panels are fully inserted into the
uprights you can tighten up the four corners of the
silver framework which will not hold the glass in
position.
GLASS RETAINING CLIPS
Next you need to fi t the Retaining Clips to hold the
glass fi rmly. Position a clip tight up to the glass on
the inside of the upper and lower rails, mark the
position and drill a small hole then fi x a screw to
hold the clip in place. Repeat top and bottom on
both fi xed glass panels.
CAUTION WHEN DRILLING - ONLY DRILL
THROUGH THE INNER SINGLE LAYER OF FRAME