Vidalux Hydro Plus Series Installation And Operating Manual page 13

FITTING THE FRONT FRAME
Place the front frame in to position and align the back panels and
center column on the tray for fixing
NOTE: A large bead of sealant MUST be run between
the back panels and Front Frame work to provide an
extra level of water protection.
Simply wipe off any excess so none will be 'on show'
Align the uprights with the rear glass panels so that the fi xing
holes line up.
To help ease this process, you may need to use the supplied
drill bit in the holes to ensure they are wide enough and
clear.
From behind the shower locate the screw holes into the front
frame through from the backpanels to secure in place.
(8 x short screws)
FIXING THE BACK PANELS TO THE TRAY
The rear glass panels can now be fi xed to the tray. Wipe away any excess sealant one completed
At the rear of the shower the lip of the frame has fi xing holes to enable the screws provided to be used
to fasten the rear glass panels to the tray. There are 4 fi xing points.
Fixing is done with the short screws provided. First use the dril piece provided to create pilot holes without
passing all the way through the tray, then when fixing, you may wish to squeeze silicone into the holes
before screwing to ensure its water tight