Vidalux Hydro Plus Series Installation And Operating Manual page 16

FITTING THE SHOWER DOOR WHEEL RUNNERS
Locate the pack of 8 twin wheel shower door runners (cams).
There are two diff erent types provided.
To fi t each of the cams, fi rst select the appropriate cam for the position on the door:
4 x Push button/Quick release for the lower position on the doors.
4 x Standard non push button for the upper position on doors.
Position the Cam Body on the outside facing side of the door (curve pointing outwards). Place the clear
rubber gasket between the cam body and the glass. The gasket will fi t into the hole on the glass.
On the inside of the door, position the grey plastic inner cam body, then washer and bolt.
Now tighten the parts together with the bolt until fi rmly held in place.
DO NOT OVER TIGHTEN AS YOU MAY BREAK THE GLASS
With the cam fi xed in position, slide on the Chrome fi nished cover.
Repeat this process of all of the cam wheels.
TO HANG THE DOORS
From inside the shower position the upper wheels into the running tracks on the inside curve of the
upper curved rail and then let the door hand down. From outside the shower, move the door to
what would be a closed position and press the quick release buttons on the top of the lower cams
and move the wheels to fit into the lower runner tracks.
Repeat for the other door.
DOOR STOPS
On the inside curve of the upper and lower rail are some
holes pre-drilled. Fix each of the 8 door stops at these
locations with the provided screws.
(image based on
top cam fi tting)
14