Front Frame - Vidalux Hydro Plus Series Installation And Operating Manual

FRONT FRAME

Locate the two silver coloured upright frame sections and the two curved frame rail sections. You will need
the 8 x LONGEST screws to join these sections together.
The inside facing edges of the rails will be tapered,
while the flat edge will meet the tray and the other will
be closest to the bathroom ceiling.
In turn, align the two holes in the uprights with the two
holes in the upper and lower curved rails. The screws
pass through the holes in the side of the upright and
fasten into the curved rail as shown in the diagram
Rails maybe same size on most
models - This is for illustration only
How To Use PTFE Tape
DO NOT FULLY TIGHTEN THE SCREWS -
ALLOW SOME MOVEMENT IN THE FRAME FOR
INSTALLING THE FIXED GLASS
PLEASE NOTE: The uprights have 'cut out
sections' that go over the trays lip, therefore
these are positioned at the bottom
Longest Screws
10