Jenoptik VARIOSCAN high resolution Series Manual page 47

Deletes the selected isotherm.
Entry of the upper isotherm limit
On deleting an isotherm, the remaining isotherms are renumbered in
ascending order. If the deleted isotherm was the only one available, the
index number "0" appears in the No key after deletion. This indicates
that no isotherm is available.
ESC Press this key to exit the isotherm editor without saving any
previous changes. The system will ask you, if the last
isotherm created shall be programmed.
SET This key serves to programme the current isotherm and exit
the isotherm editor. All previous changes will be saved.
In Freeze mode, created isotherms are switched on/off by a single click
on the ISO key.
Current background image
Use the [+] key to select the current background image. In thumbnail
presentation mode (gallery) of background images, the current
background image is shown with a white frame.
Operation
47