Jenoptik VARIOSCAN high resolution Series Manual page 39

Please note that if the internal temperature of the camera changes
quickly (e.g. after switch on) , referencing at short intervals is necessary
to avoid drift of the measured temperature values. In this case, the
chopper pause should be as short as possible.
External Trigger
In remote control mode of the camera, the following modes are
selectable:
– Retrig: Trigger sequence by repeated release of the trigger signal
– Burst: Single triggering
Display OFF !
If you use an external monitor in combination with the camera, you can
use this function to switch off the camera's display. Besides you can
utilise this option also, if you have activated the autosave function and
do not need the internal display any longer for operation and
visualisation. After switch-off of the monitor, the system switches back
to Recording Mode. You can deactivate the Display OFF! function by
pressing any key.
Layout
The options of this window allow you to customise image
synchronisation and program layout to the monitor used. To obtain
optimum image quality, this customisation is absolutely necessary.
Operation
39