Table of Contents
Advertisement
Appendix A. Display Station Setup Instructions
The display station is shipped from the factory fully
tested and adjusted. If the display station is still in the
shipping container, follow the unpacking instructions
fastened to the outside of the container.
This setup procedure should be used after the display
station is
unpac~ed
and located where it is to be used
or whenever it is disconnected and relocated.
I
DANGER
The display station has a weight of approximately 34
kilograms (75 pounds). NEVER 'LIFT IT BY
YOURSELF.
If the display station has the Keylock feature, a small
envelope containing 2 keys is taped to the machine.
Place the keys in a safe place; you will need one of
them later in these setup instructions.
Before you start the setup instructions, ensure that a
grounded power outlet is available; US
115
Vac; for
World Trade, see the installation planning representative.
If problems occur during these instructions, go to the
Start of
Call MAP.
The setup instructions are written in two sections:
• Section 1 can be completed without connecting the
displ~y
station to the system.
• Section 2 describes how to connect the display
station to the system.
Setup Instructions - Section 1
1.
Remove the front access panel cover.
2.
Plug the keyboard cable into the keyboard cable
connector.
3.
4.
5.
Verify that the Power switch is in the Off position.
Verify that the Status switch is in the Normal
position.
Plug the power cord into the grounded power
outlet.
6.
If the display station has the Keylock feature,
insert the key and turn it clockwise to the Unlock
position.
7.
Set the Power switch to the On position and turn
the Brightness control full clockwise.
8.
When the display station warms up (about
20
to
30
seconds), slowly turn the Brightness control
counterclockwise to a comfortable brightness.
The following· conditions indicate that the display station
is working properly:
-
The cursor is in the upper right corner.
-
A dash line is on the display screen to the left of
all display screen indicator labels.
-
The Ready light is on and all other lights are off.
Appendix A. Display Station Setup Instructions
5251 MIM
A-1
Advertisement
Table of Contents
