Table of Contents
Advertisement
Setup Instructions - Section 2
Before you start connecting the display station to the
system, ensure that the following is complete:
• The system operator knows that you are going to
connect the display station to the system.
• The system cable (with a proper connector) is
installed and ready to use.
• The system cable is connected to the system.
• If the display station is to be connected to a
preceding display station or printer (Cable Thru
feature) the Terminator switch on the preceding work
station must be set to position 2 (171).
9.
Set the Power switch to the Off position.
10.
To connect the system cable:
a. Insert the system cable into the cable tunnel 1
opening on the back of the machine, then push
the cable into the opening until the cable
connector appears at the front.
b. From the front, hold the cable connector and
pull enough cable out of the cable tunnel to
reach across the keyboard cable to socket 1.
2
Cable
Power
Cord
'~
System Cable
Connect the system cable to the socket 1
connector.
If your display station has the Cable Thru
feature go to step 11. If not, go to step 12.
A-2
Advertisement
Table of Contents
