Installing The Control Unit And Operator Panel; Installing The Control Unit - Siemens SINAMICS G120 Hardware Installation Manual

Installing/mounting

4.4 Installing the Control Unit and Operator Panel

4.4 Installing the Control Unit and Operator Panel
4.4.1

Installing the Control Unit

Installing the Control Unit, PM230 IP55 - FSA ... FSC
To insert or detach the Control
Unit, you must release eight or
ten fixing screws of the cover
and then remove the cover.
Insert the lugs on the rear panel
of the Control Unit into the ap-
propriate recesses of the Power
Module. Snap in the Control Unit
as shown in the illustration.
To remove, loosen the Control
Unit from the Power Module by
pressing the release lever.
Reinstall the cover before you
commission the inverter. Do not
damage the seal of the cover
when attaching it.
Using the operator panel with a CU230P-2 Control Unit
If you use an operator panel, connect the adapter provided to the Control Unit as shown in
the illustration.
Using the operator panel with a CU240B/E-2 Control Unit
With a CU240B/E-2, you will need an adapter from KnorrTec instead of the adapter
provided.
26
Accessories (Page 66)
Hardware Installation Manual, 12/2016, A5E35319202B AB
PM230 Power Module, IP55