Bottom Panel; Reset Button - ZyXEL Communications VMG4005-B60A User Manual

Table 2 LED Descriptions (continued)
LED
Ethernet

1.5.3 Bottom Panel

The connection ports are located on the bottom panel.
Figure 5 Bottom Panel
The following table describes the items on the bottom panel.
Rear Panel Ports
LABEL
DSL
LAN
Reset
Power

1.5.4 RESET Button

If you forget your password or cannot access the Web Configurator, you will need to use the RESET
button to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously. The password will be reset to the factory default (see the device label), and the
LAN IP address will be "192.168.1.1".
Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for more than 5 seconds or
2
until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults
have been restored and the device restarts.
Chapter 1 Introducing the VMG
COLOR STATUS DESCRIPTION
Green On The VMG has a successful 10/100/1000 Mbps Ethernet connection with a
device on the Local Area Network (LAN).
Blinking The VMG is sending or receiving data to/from the LAN at 10/100/1000
Mbps.
Off The VMG does not have an Ethernet connection with the LAN.
DESCRIPTION
Connect a RJ-45 cable to the DSL port for Internet access.
Connect a router/gateway to the Ethernet port for Internet access.
Press the button to return the VMG to the factory defaults.
Connect the power adapter and then can press the power button to start the VMG.
VMG4005-B50A/B60A User's Guide
13