Banner Sure Cross MultiHop DX80DR9M-H5 Instructions Manual

Sure Cross MultiHop Data Radio
®
Datasheet
®
Sure Cross MultiHop data radios are wireless industrial communication devices that extend the range of a Modbus or other serial
communication network.
900 MHz
2.4 GHz Model
For additional information, updated documentation, and a list of accessories, refer to Banner Engineering's website,
www.bannerengineering.com/wireless.
WARNING: Not To Be Used for Personnel Protection
Never use this device as a sensing device for personnel protection. Doing so could lead to serious injury or death.
This device does not include the self-checking redundant circuitry necessary to allow its use in personnel safety
applications. A sensor failure or malfunction can cause either an energized or de-energized sensor output
condition.
CAUTION: Never Operate 1 Watt Radios Without Antennas
To avoid damaging the radio circuitry, never power up Sure Cross
radios without an antenna.
CAUTION: Electrostatic Discharge (ESD)
ESD Sensitive Device. This product uses semiconductors that can be damaged by electrostatic discharge (ESD).
When performing maintenance, care must be taken so the device is not damaged. Disconnect power from the
device when accessing the internal DIP switches. Proper handling procedures include wearing anti-static wrist
straps. Damage from inappropriate handling is not covered by warranty.
Models
Models
DX80DR9M-H5
DX80DR2M-H5
DX80...C (IP20; NEMA 1) models are also available. To order this model with an IP20 housing, add a C to the
end of the model number: DX80DR9M-H5C.
Original Document
152416 Rev. H
• Wireless industrial I/O device with four sinking discrete inputs, two NMOS discrete
outputs, four 0 to 20 mA analog inputs, and two switch power outputs
• Selectable transmit power levels of 250 mW or 1 Watt for 900 MHz models and 65 mW
for 2.4 GHz models
®
• FlexPower power options allow for 10 to 30 V dc, solar, and battery power sources for
low power applications.
• Self-healing, auto-routing RF network with multiple hops extends the network's range
• Serial and I/O communication on a Modbus platform
• Message routing improves link performance
• DIP switches select operational modes: master, repeater, or slave
• Built-in site survey mode enables rapid assessment of a location's RF transmission
properties
• FHSS radios operate and synchronize automatically
Frequency I/O
900 MHz ISM Band
2.4 GHz ISM Band
22 September 2017
® Performance or Sure Cross MultiHop (1 Watt)
Inputs: Four NPN discrete, four 0 to 20 mA analog
Outputs: Two NMOS discrete
Switch Power: Two
Serial interface: RS-485
152416