Number Buttons - Philips VR1100/02X User Manual

17 Number buttons

(0, 1, 2, 3, 4, 5, 6, 7, 8
and 9)
Before using these buttons, press VCR,
TV or SAT to select yout target
component.
• Press to select a channel on the VCR
satellite tuner or TV.
To select channels 1 to 9, press 0
then the channel you want. For
example, for channel 4, press 0 then
4.
• Also used to programme the Timer
Recordings. ( P.29, P30)
18 CLEAR button
• Erases unwanted timer programmes.
( P.31)
• Resets counter to 0:00:00.
19 STILL/SLOW button
• Stops the tape during recording
(pause) or playback (still picture)
temporarily. ( P.22, P.23)
Press again to resume normal
recording.
Press PLAY 3 to resume normal
playback.
• Activates slow motion picture when
pressed for more than 2 seconds
during playback. ( P.23)
20 STILL/SLOW / £ button
• During a slow motion picture, adjusts
the playback speed in the forward
direction ( P.13)
Press PLAY 3 to resume normal
playback.
• Locates an index marked at the
beginning of every recording.
( P.23)
21 PLAY 3 / 5 button
Before using this button, press VCR or
TV to select your target component.
• After pressing VCR:
– Starts normal playback. ( P.22)
– Moves up the cursor when using
the menus. ( P.16)
• For some PHILIPS TV only:
After pressing TV, operates the TV's
menus.
22 ¡ (Fast forward) /
3 button
Before using this button, press VCR or
TV to select your target component.
• After pressing VCR:
– Fast forwards the tape. Also during
playback, starts rapid forward
visual search. ( P.21)
– Changes the setting of a menu
item. ( P.16)
• For some PHILIPS TVs only:
After pressing TV, operates the TV's
menus.
23 STOP 7 / ∞ ∞ ∞ ∞ ∞ button
• After pressing VCR:
– Stops the tape. ( P.21)
– Moves down the cursor when
using the menus. ( P.16)
• For some PHILIPS TVs only:
After pressing TV, operates the TV's
menus.
24 CH (channel) 5 / ∞ button
Before using this button, press VCR,TV
or SAT.
• After pressing VCR, changes the
channels on the VCR. Release at a
desired channel.
• After pressing TV, changes the
channels on the TV. Release at a
desired channel.
• After pressing SAT, changes the
channels on the satellite tuner.
Release at a desired channel.
25 TIMER button
Displays the Timer Recording menu.
26 REC (ord) END SEARCH
button
Press prior to recording a programme to
find the end of previously recorded
program and the unrecorded portion of
a tape. ( P.26)
To insert the batteries:
1
Remove the battery compartment lid
from the bottom of the remote
control.
2
Install two AA batteries —
R6(SUM-3)/AA — matching
polarity indicated inside the battery
compartment.
— 5 —
27 SKIP SEARCH button
Press during tape playback to fast
forward 30 seconds of a tape. ( P.23)
28 REC (record)/OTR button
• Starts recording when pressed once.
( P.22)
• Starts a recording for 30 minutes to 6
hours long. When pressed more than
once, the shut-off time increases in
30-minute intervals. ( P.26)
29 Jog dial
Advances or reverses the picture frame
by frame in the still picture mode.
( P.23)
Note:
The following buttons will glow when you
use or place the remote control in the dark
area.
• PLAY 3
• STOP 7
• ¡ (Fast forward)
• 1 (Rewind)
• VOL (ume) 5/ ∞
• CH (annel) 5/ ∞
3
Replace the lid.
Note:
This remote control and batteries are
supplied accessories.
Check to make sure they are included.
Also, check "Specifications" to see what
other accessories are included.
CAUTION
On Battery Replacement
Do not mix old and new batteries.
(Also never mix alkaline batteries
with manganese batteries.)