Philips VR1100/02X User Manual page 13

S
ETTING
Preset Download
Before performing the following steps, be sure to finish Preparation on pages 10–11.
1 ¶ If you are referring to the display window, press
5/∞ to select "CH – –" and press OK/STATUS.
Channel position number increases from
"CH 1".
Do NOT press any button on the front panel or remote control until display window
shows either the display as illustrated in step 2 or "– –:– –".
2
If the correct current time is displayed on the display window, the Auto Channel Set and Clock Set
have been completed successfully. Go to step 3.
If "1" (channel position) is displayed on the display window, the Auto Clock Set has not completed
(only the Auto Channel Set has). Go to step 3 and then perform "Clock Setting" manually. ( P.20)
¶ You can check if the Guide Channel numbers have been set correctly when you perform S
Recording ( P.29); if the correct channel position number is displayed on S
confirms that the Guide Channel number for the S
3
Set the Video Channel manually. ( P. 15)
4
Press PROGRAMME 5/∞ on the front panel (or CH 5/∞ on the remote control) to make sure that all necessary
stations have been stored in the VCR's memory.
¶ If station names (ID P.19) have also been stored in the VCR's memory, the station name will be displayed at the
top left corner of the screen for about 5 seconds when the VCR is tuned to a different station.
¶ If you want to set the tuner manually such as to add or skip channels, to change channel positions, or to set or station
names, see pages 17–18.
¶ If no station is stored in the VCR's memory, make sure the SCART cable is connected correctly and press
OK/STATUS to re-perform Preset Download.
Notes:
¶ In the area where no TV station transmits a PDC signal, the VCR can perform neither auto clock set nor auto Guide
Channel number set.
¶ If there is a power cut, or if you press STANDBY/ON, POWER or MENU while downloading or set up is on progress, it will be
interrupted; be sure to turn off the VCR power once and try again from the beginning.
¶ Auto clock may not function properly depending on the reception condition.
¶ When you perform Preset Download function, be sure to use fullywired 21-pin SCART cable.
¶ On this VCR, the characters available for station's name (ID) are A-Z, 0-9), -, *, + and
may differ from those of your TV ( P.19).
Important
7 In certain reception conditions, station names may not be stored correctly, and auto Guide Channel Number Set may not work
properly. If the Guide Channel numbers are not set properly, when you timer-record a TV programme using the S
VCR will record a TV programme of a different station. When programming the timer using the S
whether the channel position on which your VCR receives the broadcasting station you wish to record is selected. ( P.29)
U
P
(C
ONTINUED
)
¶ If you are referring to the on-screen display, press 5/∞
to select "FOLLOW TV" and press OK/STATUS.
AUTO CH. SET
\FOLLOW TV
SELECT: 5 ∞
CONFIRM: OK
END : MENU
HOW
V number you enter has been set correctly.
HOW IEW
— 14 —
FOLLOW TV
PLEASE WAIT
END : MENU
GUIDE CH. SET
PLEASE WAIT
END : MENU
V Timer
HOW IEW
V Programme screen, this
IEW
(space). Some downloaded station's name
V
HOW IEW
V system, be sure to check
HOW IEW
system, the