Table of Contents
Advertisement
IT1000 Basic Rate ISDN Tester
When the test is starts to run, you will see a confirmation screen like this :
The results of the test are displayed on the tester itself by means of the Pass / Err indicator and also
on the connected computer by displaying one of the following screens :
The tester will give an audible confirmation of the test result by means of its internal speaker and if
the Enable Sounds option is enabled on the Options menu, you should also receive an audible
confirmation via your computer's built-in speaker.
ü
Whenever the spinning world logo is displayed the test being run can be cancelled by pressing the ESC key.
Note that currently, this does not actually halt a D or B Channel test in progress, but does stop the unit
waiting to display the results
4.4 Options
By means of the Options menu in IT-Explorer, you can change the way your tester operates.
4.4.1
Com Port Settings
It is important that you set the software to the correct COM port settings in order for the IT Explorer
software to be able to communicate correctly with the unit. These settings are contained within the
options menu and can be accessed via Options > Com Port Settings.
Z
Note that it is not normally necessary to change any of these settings except to match the COM port to the one
actually in use on your computer.
4.4.2
Initialisation String
With this option, you can send a Hayes® type command such as 'ATE1' (to enable echo) to the unit
when it is initialised. This option is used when the unit is in Terminal Adaptor mode.
SALES: 0870 90 10 750
22
Advertisement
Table of Contents
