Table of Contents
Advertisement
The correct indicator combinations for all stand alone tests are shown below :
Test Function
Data Call D Channel
Data Call B Channel
Outbound Voice Call
Inbound Voice Answering
Email logs to remote user
Line Voltage
3.2.4
Running the test
When the required test is indicated, the MODE / RUN button is then pressed and held for 3 seconds
to start the test cycle.
What happens next depends on the test selected. For example, the voice test will call a specified
number and deliver a message saying that that test was successful. If a data test was selected, the
unit will attempt to set up a data circuit between the B1 and B2 channels.
A full specification of the default tests as pre-configured from the factory are given in Chapter 4.
3.2.5
Test Results
Regardless of the test selected, the result is displayed on the Pass / Fail indicator together with a
musical tone from the internal speaker as follows :
•
A
GREEN
performed satisfactorily.
•
A
RED
programmed tests failed. A note is written to the error log which can be examined via the
DTE port (see 2.3 below)
3.2.6
Turning the Unit Off
Your IT1000 is equipped with an 'auto power off' feature which will switch the unit off to conserve
battery power whenever there has been no activity for a certain time. The power off delay is user
configurable and can be changed in IT1000 Explorer Options >Configure IT1000 menu.
indicator together with a rising tone indicates that all the programmed tests were
indicator together a descending musical tone indicates that one or more of the
IT1000 Basic Rate ISDN Tester
B1
B2
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
TECHNICAL: 0870 90 10 750
Pass/Fail
OFF
OFF
OFF
ON
ON
ON
15
Advertisement
Table of Contents
