Table of Contents
Advertisement
IT1000 Basic Rate ISDN Tester
Make sure that before attempting to send e-mails you have configured the unit for an ISP where you
have a valid account or this test will fail. Configuring this is a three step process :
STEP 1 - Connect to the tester
Use the IT-Explorer software to connect to your local tester as described in Section 2
STEP 2 - Configure your SMTP Server
Use the drop down 'Select Test' menu to select the Send Email test, then click on the
Configure Test button. Fill in the blank fields with the appropriate information.
STEP 3 - Save Changes
The changes just made will be lost when the power is removed from your unit unless they are
permanently saved using Options > Save Changes to Tester.
When you have completed these three steps the unit will be able to send e-mails on demand from the
front panel buttons or by the Run Test option in IT-Explorer.
By default the email contains the event log and a protocol analysis of the Layer 1,2 and 3 events at
the time the e-mail is requested, but you can change this by using the IT-Explorer software.
5.9 Record New Voice Message
It is possible to change the voice message played when the unit is used in Voice Answer or Voice
Call mode. To do this select Record new voice message from the Options menu and follow the
instructions given.
You will be asked to enter a telephone number and the unit will use this number to call you. You
will need to be in sight of the screen when the unit calls. When you pick up the handset immediately
begin to record your new message then click the Hang Up button on your PC.
The unit will then compress the voice and store it in the flash memory.
You can toggle between the Factory default message and the 'Custom' message by using Options >
Configure IT1000.
SALES: 0870 90 10 750
32
Advertisement
Table of Contents
