Lenovo ThinkSystem HR650X User Manual And Hardware Maintenance Manual page 46

PCI SubsystemSettings
PCI Bus Driver Version
One Blank line
PCI Devices Common Settings:
Above 4G Decoding
SR-IOV Support
Network Stack Configuration Table(Sub of
Network Stack Configuration
Network Stack
Ipv4 PXE Support
Ipv4 HTTP Support
© Copyright Lenovo 2017
Bits per 9600/1920
second 0/57600/11
5200
Flow None/Hard
Control ware
RTS/CTS
/Software
Xon/Xoff
Data Bits 8
Parity None
Stop Bits 1
PCI SubsystemSettings Table(Sub of
A5.01.11
Disabled/Enabled
Disabled/Enabled
Disabled/Enabled
Disabled/Enabled
Disabled/Enabled
Type/Emulation.
Selects serial port transmission speed. The speed
must be matched on the other side. Long or noisy
lines may require lower speeds.
Flow control can prevent data loss from buffer
overflow. When sending data, if the receiving
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a 'start'
signal can be sent to re-start the flow. Hardware
flow control uses two wires to send start/stop
signals.
Advanced Menu
PCI, PCI-X and PCI Express Settings.
Enables or Disables 64bit capable Devices to be
Decoded in Above 4G Address Space (Only if
System Supports 64 bit PCI Decoding).
If system has SR-IOV capable PCIe Devices, this
option Enables or Disables Single Root IO
Virtualization Support.
Advanced Menu
Network Stack Settings
Enable/Disable UEFI Network Stack
Enable Ipv4 PXE Boot Support. If disabled IPV4 PXE
boot option will not be created
Enable Ipv4 HTTP Boot Support. If disabled IPV4
HTTP boot option will not be created
)
)
46