Maintenance - Schaudt Electroblock EBL 220-4 A Instruction Manual

Electroblock EBL 220-4 A / EBL 220-4 with OVP instruction manual
Fold-away bed, awning,
gas alarm, waste water
valve and awning light
Tank heating
D+switching
Switch panel ST ...
Cleaning
12
The power supply to these consumers will be disconnected automatically as
soon as the engine is running (the D+ connection supplies the voltage in this
case). The awning light can also be used if the 12 V power supply is
switched off.
The tank heating is switched on from the DT/LT ... control and switch panel.
The input D+ can be adapted to the D+ of the vehicle:
D+ vehicle: active high
F
D+ vehicle: active low
F
The adjustment is correctly ex works.
The switch panel ST ... is an optional extension for the electroblock
EBL 220-4. Via three buttons consumers can be switched off individually.
If the switch panel ST ... is not available, a strapping plug must be connec-
ted to block BL11 of the electroblock EBL 220-4 (also see block diagram,
appendix F).

Maintenance

5
The electroblock requires no maintenance.
Clean the Electroblock using a soft, moist cloth and mild detergent. Never
use spirit, thinners or similar substances. Do not allow fluid to ingress the
Electroblock.
The reproduction, translation and duplication of this manual, even in parts, is
E
not allowed without written authorisation.
Issued: 21.06.2010 811.592 BA / EN