Additional Items; Ethernet Devices - Cisco 807 Hardware Installation Manual


IR807 Printed Document Of Compliance

Grounding Lug Kit

Power Connector

Additional Items

The following items are not shipped with the router but are required for installation:

Screws for mounting the router on a wall.

Wire crimper for chassis grounding.

Wire for connecting the chassis to an earth ground.

Ethernet cables for connecting devices to the Ethernet ports.

Ratcheting torque flathead screwdriver that exerts up to 15 in-lb (1.69 N-m) of pressure.

A number-2 Phillips screwdriver.

Ethernet Devices

Identify the Ethernet devices that you will connect to the router: hub, servers, and workstations or PCs. Ensure that each
device has a network interface card (NIC) for connecting to Ethernet ports.
Installing the Router
This section describes how to install the Cisco 807 ISR. This router can be installed on a table top or other flat horizontal
surface, mounted on a wall, or DIN rail.
The recommended clearance when horizontally mounted is 1 inch on non-connector sides and 2 inches on bottom.
Stacking heat-dissipating objects on top of the router is not allowed. I/O side clearance is needed as it is required to
access the cable connections.
Clearance is required to attach, mount the DIN rail bracket, and Wall mount bracket. The same clearances apply when
mounted vertically.
This section also describes how to attach external antennas to the routers and contains the following topics:

Warnings, page 28

Accessing the SIM Slots, page 29

Installing Antennas, page 30

Mounting on a Wall, Table, or Other Flat Surface, page 31

Installing a DIN Rail, page 32

Installing the Router Ground Connection, page 34
Warnings
WARNING: For NEC-compliant grounding, use size 14 AWG (1.6mm) or larger copper wire and a ring terminal with an
inner diameter of 1/4 in. (5 to 7 mm).
28