Cisco 807 Hardware Installation Manual page 24


Cable: 4 ft RG174 VW-1 compliant

Height and base diameter: 90 mm and 137 mm

Temperature rating: -40° to 185°F (-40° to 85°C)

Mounting: 5/8-inch lug with serrated face nut (5/8-inch diameter hole through mounting surface)

Can be used with the following cable extensions: 4G-CAB-ULL-20 and 4G-CAB-ULL-50
4G-LTE-ANTM-O-3-X
Description:

Multiband low profile indoor or outdoor omnidirectional antenna (IP67 ingress protection)

Ceiling mount, dual 4G LTE and standalone GPS
Electrical Specifications:

Frequency range: 698 to 960 MHz and 1710 to 2700 MHz

Gain: 2.5 dBi

Maximum power: 3W

Connector: SMA with TNC male adapters, and SMA for GPS

VSWR: < 2.5:1

Nominal impedance: 50 Ohms

Polarization: linear vertical
Mechanical Specifications:

Radome material: white, black, red, or blue ABS, UL-94 V0

Cable: 4 ft RG174 VW-1 compliant

Height and base diameter: 90 mm and 137 mm

Temperature rating: -40° to 185°F (-40° to 85°C)

Mounting: 5/8-inch lug with serrated face nut (5/8-inch diameter hole through mounting surface)

Can be used with the following cable extensions: 4G-CAB-ULL-20 and 4G-CAB-ULL-50
4G-LTE-ANTM-D
Description:

Omnidirectional dipole antenna is designed for indoor use with Cisco 4G and Cisco 3G wireless Integrated Services
Routers Generation 2 systems

Articulating Joint —It can be rotated 360 degrees and is capable of maneuvering into three stop positions: 0 degrees,
45 degrees, and 90 degrees.

Male threaded Neill-Concelman (TNC) Connector —It lets you directly mount the antenna to any Cisco 4G and Cisco
3G wireless Integrated Services Router (ISR) EHWIC with a TNC connector (Cisco 4G-LTE-ANTM-D Ominidirectional
Dipole Antenna, TNC Connector, and Articulation Joint). The threads on the connector must comply with the ANSI
7/16-28 UNEF 2B thread specification.
Electrical Specifications:
22