Table of Contents
Advertisement
IMPORTANT!
Before you do troubleshooting
WARNING!
•
Risk of physical injury!
•
Cut injury when the blade turns or
the product starts accidentally.
•
Wait for the blade to stop, disconnect
the product from the mains and use
gloves before you do
troubleshooting.
To clean the bumper
Clean the bumper when the adjust knob (20) locks.
1. Remove the 2 R-clips (8) of the handle locks on
both sides.
8
9
10
17
Troubleshooting table
Problem
Engine does not start.
Engine is jammed and makes a
noise.
17 - 001 -
Make sure that the product is discarded through or
via your municipal recycling collection centre.
Troubleshooting
2. Turn the adjust knob (20) to level 1.
3. Tilt the lower handle (9) forward.
4. Remove the bumper (17) of the mower body
5. Clean the bumper (17).
6. Assemble the bumper (see Assembly).
To replace the blade
The FLYMO spare parts are availible from your
FLYMO dealer or from the FLYMO service.
Only use an original FLYMO blade:
•
8
1. Let the blade replace by the FLYMO Service or a
20
Possible Cause
Extension cable is disconnected or
damaged
Blade is blocked.
Blade is blocked.
(10).
WARNING!
•
Risk of physical injury!
•
Cut injury when the blade turns and it
is damaged, bent, out of balance or
has chipped edges.
•
Do not use the product when the
blade is damaged, bent, out of
balance or has chipped edges.
•
Do not regrind the blade.
FLYMO replacement blade reference no.
FLY070. Part no. 5898064-90.
specialist dealer authorised by FLYMO .
Remedy
Connect the extension cable or if
necessary replace it.
Remove the obstacle.
Remove the obstacle.
13
Hide quick links:
Advertisement
Table of Contents
