Advertisement
cAUtion: Always wear eye protection.
stArtinG And stoppinG (Fig. 7)
1. Squeeze the trigger switch (2) to start the trimmer.
2. Release the trigger switch to stop the trimmer.
Fig. 7
triMMinG
1. Use the trimmer at an angle of approximately 15-degree to the working area (Fig.8).
2. Slowly swing the trimmer from side to side(Fig.9).
3. Do not overload your trimmer, take small "bites" this will keep machine operating at high speed and will greatly
improve cutting efficiency, (Fig.10).
4. Cutting close to a wall
Use the edge guide when cutting close to an edge.
MAnUALLY Feed Line (Fig.11)
If required line can be fed out manually, press and release manual line feed button (11), whilst gently pull out the
lines until the lines reach the line cutter.
When the required amount of line is fed out, gently pull on the second line (there is no need to press the manual
line feed button again)
If the line extends past the line cutter, too much line has been fed out.
If too much line is fed out, remove the spool cap and click spool anti-clockwise until the line is at the desired
length.
Fig. 11
operAtion
2
Fig. 8
11
Fig. 9
9
Fig. 10
Advertisement
