External Power Connector; Leds; Factory Reset Button; Screw Terminals - Measurement Computing E-1608 User Manual

Distributed by MicroDAQ.com, Ltd.
E-1608 User's Guide
The maximum communication distance without using a repeater is 100 meters. You can send your data
100 meters at data speeds of up to 100 Mbps using only one Ethernet cable connected to your computer.

External power connector

Connect the 5 V external power adapter (PS-5V1AEPS) to this connector to provide 5 V external power to the
E-1608.

LEDs

The LED is steady green when external power between 3.3V to 5.9 V is supplied to the E-1608.
Power
The LED turns off when:
Power

power is not supplied by the external supply (make sure that the supply is fully connected to the power
connector)

the input power is outside of the specified voltage range of the external supply (3.3V to 5.9 V ), causing a
power fault
The E-1608 has an onboard voltage supervisory circuit that monitors the 5 V external power supply.
The Activity LED is on when there is a valid host connection, and blinks when a command is received or an
analog input scan is running.
Ethernet connector LEDS
The green Link/activity
link, and blinks when network activity is detected.
The yellow Speed
100 Mbps, and off when the transmission speed is 10 Mbps or there is no link.

Factory reset button

Use the factory reset button to reset network configuration settings to the factory default values.
Refer to Restoring factory default network settings

Screw terminals

The E-1608 device screw terminals provide the following connections:

Eight SE or four DIFF (

Eight digital I/O connections (

Two analog output connections (

One external clock input (

One digital trigger input (

One counter input (

One power output (

Six analog ground (
LED on the lower left of the Ethernet connector is on when there is a valid Ethernet
LED on the lower right of the Ethernet connector is on when the transmission speed is
CH0H/CH0L to CH3H/CH3L
to
DIO0 DIO7
AOUT0
AICKI ) and one external clock output (
)
TRIG
)
CTR
+VO )
AGND ) and three digital ground (
www.MicroDAQ.com
on page 10 to learn about resetting these values.
) analog input connections
)
, AOUT1 )
AICKO
GND ) connections
12
(603) 746-5524
Functional Details
) for analog inputs