Vax ONE PWR CORDLESS BLADE 4 Series User Manual page 8

GETTING STARTED
OPERATION
Press the on/off button to switch the
machine on.
NOTE: The powered head brushbar should be ON for carpets and OFF for hard floors.
Constant use of the boost mode and brushbar will reduce the battery run time.
When the machine is in use the battery
level indicator lights will illuminate
indicating how much charge is
remaining. When less than 20% charge
is remaining the bottom light will flash
red indicating the battery is running low
and charging is required.
CAUTION: If the brushbar in the powered head has been obstructed,
the brushbar motor protection sensor may have been activated. The
brushbar will stop, the light on the powered head will illuminate red
and the machine may switch off. To reset remove the powered head
from the reach wand/handheld and clear any obstruction. Wait 1
minute before refitting the powered head tool, switch the machine on
and press the brushbar ON/OFF button.
Press the brushbar on/off button to
switch the brushbar on.
All of the accessories, including the
powered head can be attached directly
onto the handheld or the reach wand.
The crevice tool and dusting brush
can be used for hard to reach places
and at different heights for above floor
cleaning.
support.vax.co.uk
Press the boost button on to increase
the suction for particularly dirty areas.
8