Read this user guide completely before using the machine. Keep this user Only Vax recommended charger, guide for reference. If you pass your tools and accessories should be used machine on to third parties, it must with this stick vac and always check be accompanied with this user guide.
Page 3
Safety Always use the charger supplied with the stick vac. If charging the stick This appliance is not intended for vac through an extension cord, use use by persons (including children) only SAA approved 10amp extension. with reduced physical, sensory Care should be taken to arrange the or mental capabilities, or lack of extension cord as it can be a trip...
Page 4
Storage battery pack. Do not use a battery pack or charger Store your stick vac in a cool, dry area. If filters have been cleaned as that has been dropped or received per user guide instructions ensure a sharp blow. A damaged battery is they are thoroughly dry before storing subject to explosion.
Page 5
The appliance must be disconnected batteries to become contaminated with from the supply mains when ever any material which could removing the battery. be conductive. The battery is to be disposed of Remove the plug of the product safely. from the power socket when it is not in use or when cleaning it.
Page 6
WELCOME TO VAX Thank you for buying the Vax BLADE 2 MAX, we hope you enjoy using your new product. This user guide will help you get the most out of your machine and gives advice on maintenance and cleaning.
Page 8
Technical Specification Charger Specification Accessories & Consumables Blade 2 Max ZD36W420070 Model No. VX82F Name Model number Pre-motor filter VX82 100-240V ~ 50/60Hz Model number Input voltage To purchase consumables and 1.0A Max Battery voltage 36.5V accessories, please visit vax.com.au / 42.0V...
GETTING TO KNOW YOUR MACHINE 3. Holding the wall bracket securely Fig. 1 against the wall, use a pencil to make a small mark for each screw. (Fig. 5 /2 ) A. Carry handle Use the screws and wall plugs to secure B.
Page 13
When less than 20% charge is remaining 3. To increase suction for particularly the bottom light will flash red indicating dirty areas that require additional cleaning boost mode can be activated (Fig. 9 /3). the battery is running low and charging is required (Fig.
Page 14
2. To refit, line up the dirt container 3. Tap the separator over a bin to remove connection with the stick vac handle dirt and debris and wipe over the metal (Fig. 12/1). Press the dirt container shroud with a dry cloth (Fig. 16/1). release latch (Fig.
Checking for blockages The brushbar on the powered head has not been activated. Go to Using the 1. Press the handheld release button and stick vac. remove the reach wand. Check and clear any dirt and debris from the handheld The powered head may be blocked.
Page 16
Distributed by Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC 3149, Melbourne, Australia Careline AU: 1300 VAX AUS (1300 829 287) www.vax.com.au Techtronic Industries N.Z. Limited 2 Landing Drive, Mangere, Auckland, 2022, New Zealand Careline NZ: 0800 VAX NZL (0800 829 695) www.vax.co.nz...
Need help?
Do you have a question about the VX82 and is the answer not in the manual?
Questions and answers