Input channel mixing section
MODE switches (1-12, 13/14-19/20, 21/22)
q
Use these to select the input source for each channel. (See
"Setting the MODE switch" on page 36.)
COMP knobs and indicators (1-12)
w
Use these knobs to adjust the compression thresholds for the
signals input to each channel.
When compression is activated, the COMP indicators light.
EQ knobs (1-12, 13/14-19/20)
e
i Use these to boost and attenuate the HIGH, MID and LOW
bands of each channel.
Setting range: ±15 dB
i The central frequencies of the MID bands can be set for
channels 1-12.
Setting range: 100 Hz – 8 kHz (default: 600Hz)
i Channels 13/14-19/20 are fixed at 2.5 kHz.
MON 1/MON 2 knobs (1-12, 13/14-19/20, 21/22)
r
Use these to adjust the levels of signals sent to the MONITOR
OUT 1/2 buses.
FX knobs (1-12, 13/14-19/20)
t
Use to adjust the levels of the signals sent to the FX bus.
PAN knobs (1-12, 13/14-19/20, 21/22)
y
Use to adjust the stereo positions of the signals input to each
channel.
NOTE
i When PAN knobs are centered (C), signals are reduced by 3
dB and sent to both left and right MAIN MIX L/R buses.
i When a PAN knob is turned all the way to the left (L), that
channel signal is sent only to the left MAIN MIX L/R bus. It is
not sent to the right bus.
i When a PAN knob is turned all the way to the right (R), that
channel signal is sent only to the right MAIN MIX L/R bus. It is
not sent to the left bus.
2 – Names and Functions of Parts
REC buttons and indicators (1-12, 13/14-19/20,
u
21/22)
Use these to select the channels to record to the SD card.
MUTE switches and indicators (1-12, 13/14-19/20,
i
21/22)
When these switches are on (pushed in, MUTE indicator lit),
those channels are muted.
Channel faders (1-12, 13/14-19/20, 21/22)
o
Use these to adjust the send levels of channel signals.
MAIN switches (1-12, 13/14-19/20, 21/22)
p
Turn these switches on (pushed in) to send channel signals to
the MAIN MIX L/R bus.
SUB switches (1-12, 13/14-19/20, 21/22)
a
Turn these switches on (pushed in) to send channel signals to
the SUB L/R bus.
PFL switches (1-12, 13/14-19/20, 21/22)
s
Turn these switches on (pushed in) to send channel signals to
the PFL/AFL L/R bus.
ON/MUTE switch
d
Set this switch to ON to input audio from a paired Bluetooth
device.
PAIRING button and indicator
f
Press and hold this button to activate Bluetooth pairing
mode.
Press when pairing to end pairing mode. (See "Connecting
with Bluetooth devices" on page 29.)
21
TASCAM Model 24