Names And Functions Of Parts; Top Panel; Input Channel Mixing Section-1 - Tascam 12 Owner's Manual

2 - Names and Functions of Parts

Top panel

a Input channel mixing section-1
Use this section to adjust the input levels of each channel.
b Input channel mixing section-2
Use this section to choose input sources for each channel,
adjust compressors and equalizers, and set levels sent to
each bus (MAIN MIX L/R, SOLO L/R, AUX1, AUX2/FX, SUB L/R).
(see "Input channel mixing section-2" on page 13)
c Equalizer section
Use this section to connect headphones and adjust the output
equalizer. (see "Equalizer section" on page 14)

Input channel mixing section-1

1 GAIN knobs and SIG indicators (1-6, 7/8-9/10)
Use the GAIN knobs to adjust the input levels of each
channel.
its SIG indicator will light green when a signal is input (-40dB
or higher).
If a SIG indicator stays lit red continuously, lower the GAIN
knob.
12
TASCAM Model 12
d Screen operation section
Use this section to operate the meter, home and MENU
screens shown on the display. (see "Screen operation section"
on page 14)
e Monitoring section
Switch Bluetooth device input destinations, switch
monitoring destinations, and adjust AUX OUTPUT AUX 1/2
jack output levels. (see "Monitoring section" on page 15)
f Analog output adjustment section
Adjust the output levels of the built-in effects, and the
MAIN OUTPUT and SUB OUTPUT jacks. (see "Analog output
adjustment section" on page 16)
2 LOW CUT switches (1-6, 7/8-9/10)
Turn this switch on (pushed in) to enable low cut filters that
cut noise and other sounds at low frequencies.
3 INST switches (1-6, 7/8-9/10)
Set according to the MIC/LINE (BAL)/INST TRS input jack input
sources.
Turn the INST switch on (pushed in) when connecting an
guitar, bass or other equipment with high output impedance.
Turn the INST switch off (not pushed in) when connecting
electronic instruments, audio devices, mics and other
equipment.