Analog Input Jack Section - Tascam 24 Owner's Manual

Multitrack live recording console
Hide thumbs Also See for 24:
Table of Contents

Advertisement

Available languages

Available languages

2 – Names and Functions of Parts

Analog input jack section

MIC input jacks (1-12, 13/14-19/20)
1
These are balanced XLR jacks for mic input.
o XLR (1: GND, 2: HOT, 3: COLD)
LINE/INST (BAL) mono input jacks (1-2)
2
These standard TRS jacks are mono line inputs.
When directly connecting a guitar, bass or other instrument,
set the INST switch to on (pushed in).
o TRS (Tip: HOT, Ring: COLD, Sleeve: GND)
LINE (BAL) input jacks (3-12)
3
These standard TRS jacks are line inputs.
o TRS (Tip: HOT, Ring: COLD, Sleeve: GND)
L/MONO (BAL)/R (BAL) stereo input jacks (13/14-
4
19/20)
These standard TRS jacks are stereo line inputs.
If only the L/MONO (BAL) jack in a pair is connected, the
same signal was be sent to both left and right channels.
o TRS (Tip: HOT, Ring: COLD, Sleeve: GND)
−10dBV (external input) jacks (21/22, RCA pin)
5
These RCA pin jacks are analog line inputs.
Use RCA cables to connect CD players and similar devices to
these jacks.
STEREO input jack (21/22, stereo mini)
6
This stereo mini jack is a line input jack.
Use this to connect with the line output jack of a tablet or
other external device.
INSERT jacks (1-2, standard)
7
Use these standard TRS jacks to connect external devices
(effects).
o TRS (Tip: SEND, Ring: RETURN, Sleeve: GND)
GAIN knobs and SIG indicators (1-12, 13/14-19/20)
8
Use the GAIN knobs to adjust the input levels of each chan-
nel.
its SIG indicator will light green when a signal is input (−
56dB or higher).
If a SIG indicator stays lit red continuously, lower the GAIN
knob.
20
TASCAM Model 24
LOW CUT switches (1-12, 13/14-19/20)
9
Turn this switch on (pushed in) to enable low cut filters that
cut noise and other sounds at low frequencies.
INST switches (1-2)
0
Set according to the LINE/INST (BAL) input jack input sourc-
es.
Turn the INST switch on (pushed in) when connecting an
guitar, bass or other equipment with high output impedance.
Turn the INST switch off (not pushed in) when connecting
electronic instruments, audio devices, mics and other equip-
ment.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Model 16

Table of Contents