Ea30 Scan Engine - Honeywell CK75 Repair Manual

TITLE
CK75 Repair Manual
Installation
1.
Slide the flex through the slot in the scan bracket assembly.
2.
Position the camera and shield into the scan bracket assembly.
3.
Using a #0 Phillips screwdriver install 4 screws and secure the camera to the scan bracket assembly with 1.2+/-0.2 in-lbs of
torque.
4.
Verify that the grounding gasket is still attached to the camera flex as shown in the picture above. If this is a new camera you
will need to install a new grounding gasket (item 7).
5.
Re-install the scan bracket assembly.
6.
Re-install the bottom housing assembly.
OPERATION:

EA30 Scan Engine

The EA30 scan engine is located on the scan bracket assembly. To service the scan engine you will need to remove the
scan bracket assembly.
Model
CK75
1
4
6
L3-GLBL-RPR-4516 (Rev A)
DOCUMENT NO.
L3-GLBL-RPR-4254
(Rev A)
2
3
5
PAGE
Page 35 of 42
7