Charging - Cake Kalk& Manual

2.4 Charging

When charging the bike, do the following steps. ALWAYS read the
charging manual before charging. Please check the charger specific
manual at www.ridecake.com/manuals to if you have any questions
regarding your charger.
1. Make sure that the battery is connected to the bike.
2. Make sure that your chargers voltage settings corresponds to the
voltage in your outlet. If the charger has the wrong settings, it will break.
If you're unsure on what Voltage you use in your country, try a Google
search or calling your electric utility provider.
3. Start with connecting the charger to the bike before you connect the
charger to the outlet. This is a smart charger that will recognize if it has
a connection with a battery. If it does not get any connection with the
bike, it will go into "error mode" (red light) and stop the charging. This
happens if you leave the charger in the outlet without connecting it
to the bike as a safety measure. To restart your charger from the "Error
mode", remove the charger from the wall and wait for the LEDs on the
charger to stop glowing (around 30 seconds). Then proceed with this
list from step 1.
4. Plug the charger into the outlet.
5. When the bike is fully charged. The charger's LED will show "FULL" in green.
6. Don't forget to put the plastic plug into the charger port to avoid dirt
and damage to the plug.
• Never charge the bike without supervision.
• Never let the bike charge unattended.
• Never use the charger in any other application than with the CAKE Kalk& bike.
• Never use any other charger than the original CAKE charger.
• Never have the kill switch on the handlebar connected as the bike can be
turned on and ridden while the charger is connected. This can cause
severe injuries to people or properties.