Cake Kalk& Manual page 7

Kill switch
The kill switch is located on the right side of the handlebar. When the kill switch
is connected with the magnet, the bike is turned on.
When you are done riding or in case of an emergency, pull the kill switch
to turn off the bike.
ALWAYS wear the kill switch strap around your wrist when riding. This is to
prevent further damage to the rider, the vehicle or other property. When
falling, losing control or feeling unsafe, release your right hand from the
handlebar and pull it back, this will disconnect the kill switch and turn the
bike off.
ALWAYS disconnect the kill switch when not riding. As the bike is electric,
it's hard for bystanders to know if the bike is on or not. This can cause
accidents if people are pulling the throttle while expecting a turned off bike.
Display
The display on the stem is the bike's control panel. Here, you will be able
to see the speedometer, odometer, trip meter, Power mode, Brake mode,
Service intervals, Warning signals and Limiters and Error codes.
Operating the display
When the bike has been turned on. Press and hold the button to the left
to activate the bike.
Changing Power mode
When the bike has been activated. Press the button middle left to change
Power mode. You will always change the Power mode, starting from "1 -
Easy" to "2 - Medium to "3 - Full" and back to "1 - Easy" again, one press
at a time. The bike will make a different sound depending on the selected
riding mode.