Starting Procedure; Charging - Cake Kalk Manual

Power mode 3 - Exceed
With no restrictions when it comes to the performance, this mode is perfect
when you need all power available. This mode is highly recommended for
highly skilled riders only.

Charging

When charging the bike, do the following steps.
ALWAYS read the charging manual before charging.
1. Make sure that the battery is connected to the bike (both connectors
from battery, both the big red one and the small yellow one)
2. Disconnect the killswitch
3. Turn on the master switch (pointing upwards)
4. Plug the charger into the outlet (220V)
5. Plug the charger into the bike (charger connector can be found under the
bike, close to the triple clamps)
When the charger is connected, it will show a red light. When the charging
is done, it will light in green. When the charging is finished, don't forget to
put the rubber cap on the connector, not to break it during riding.
• Never charge the bike without supervision.
• Never let the bike charge unattended.
• Never use the charger in any other application than with the CAKE bike.
• Never use any other charger than the original CAKE charger.
• Never have the kill switch on the handlebar connected as the bike can be
turned on and ridden while the charger is connected. This can cause seve
re injuries to people or properties.

2.3 Starting procedure

Before you start the vehicle, please remember that this is an all-electric
vehicle which is completely silent when it's on.
Battery connected
To see if the battery is connected properly. Remove the saddle by uns-
crewing the 2 screws found under the saddle with a 5MM Allen key. When
the saddle is removed, check that the big red contact is undamaged and
connected tightly. You can leave the battery connected to the bike during
longer periods of time (such as storage) as long as you turn off the master
switch.
The master switch
After you are certain that the battery is properly connected you move on to
the master switch. The master switch is located on the front of the battery
cover (see picture below). When the master switch is turned off (pointing
down), all of the electricity in the bike is turned off as the battery is
electrically disconnected from the rest of the system. The master switch
needs to be turned on, pointing upwards, in order to ride or charge the
bike. When the bike is not in use for longer periods of time (a week or
longer), the master switch should be turned off in order for the bikes
standby mode not to drain the battery slowly.
Kill switch
The kill switch is located on the right side of the handlebar.
When the kill switch is connected with the magnet, the bike is turned on.
When you are done riding or in case of an emergency, pull the kill switch to
turn off the bike. ALWAYS wear the kill switch strap around your wrist when
riding. This is to prevent further damage to the rider, the vehicle or other
property. When falling, losing control or feeling unsafe, release your right
hand from the handlebar and pull it back, this will disconnect the kill switch
and turn the bike off. Always disconnect the kill switch when not riding. As
the bike makes no noise when on standby mode, it's impossible for bystan-
ders to know if the bike is on or not. This can cause accidents if people are
pulling the throttle while expecting a turned off bike.