Troubleshooting - Husqvarna CRT 36-25 Operator's Manual

CRT 36
4.16

Troubleshooting

Problem
Engine does not start.
Machine out of balance; wobbling
excessively.
Poor handling; excessive range in
control lever movement.
wc_tx000640gb.fm
Reason
Engine problem.
Operator is over-steering.
Trowel arm(s) bent.
Trowel blade(s) bent.
Main shaft(s) bent due to machine
being dropped.
Worn bushings due to lack of
lubrication.
Control arm lever adjustment has
moved or control arm has been
bent.
Lower control arm(s) bent. This
can be caused by dropping
machine.
45
Maintenance
Remedy
Consult engine manufacturer's
service manual.
The movement of each gearbox is
controlled by "stops" to provide
the correct relationship of the
control arm movement to machine
movement. Excessive pressure
on control arms in any direction
will not improve reaction time and
can damage steering controls
causing machine to wobble.
Replace trowel arm(s).
Replace trowel blade(s).
Replace main shafts.
Replace bushings and lubricate at
least every 20 hours.
Reset control arm lever.
Replace lower control arm(s). Use
lifting brackets and/or forklift
pockets provided on machine for
lifting.