Husqvarna CRT 36-25 Operator's Manual page 72

Complete Service and Repairs Before
Machine is Released
Tighten all bolts, fittings, and connections to torques
specified by the manufacturer.
Inspect for leftover components such as cotter pins,
washers, locknuts, etc. after completing service.
Replace any missing parts.
Start the engine and check for leaks. (See page 27,
Hydraulic System Hazards.) Operate all controls to
make sure the machine is functioning properly. Test
the machine if necessary. After testing, shut down and
check the work you performed.
32
Perform Maintenance Safely
Pressurized fluid
can inject into
the body
Recheck all fluid levels before releasing the equipment
for operation.
All parts should be inspected during repair and replaced
if worn, cracked or damaged. Excessively worn or
damaged parts could fail and cause injury or death.
Install all guards, covers, and shields after servicing.
Refill and recharge pressure systems only with
manufacturer-approved or recommended fluids.
Notes
Verify service work
when completed
31 31