Engine Oil And Filter (Wacker Neuson Engine) - Husqvarna CRT 36-25 Operator's Manual

CRT 36
4.14

Engine Oil and Filter (Wacker Neuson engine)

Drain the oil while the engine is still warm. To drain oil:
1. Remove the filler cap (a) and drain cap (d). Drain oil into a suitable container.
Note: In the interests of environmental protection, place plastic sheeting and a
container under the machine to collect the liquid which drains off. Dispose of this
liquid properly.
2. Re-insert the drain cap and tighten.
3. Fill the engine with the recommended oil to the upper limit mark on the dipstick
(b). See section Technical Data for the oil quantity and type.
Burn hazard. Care must be taken when draining hot engine oil. Hot oil can burn!
WARNING
To change the filter:
1. Drain the engine oil. Remove used filter.
2. Before installing the new filter, lightly oil the filter gasket (c) with fresh, clean
engine oil. Screw the filter on by hand until the gasket makes contact, then
tighten an additional 7/8 turn.
3. Fill the engine with the recommended oil. See section Technical Data for oil
quantity and type.
4. Start and run the engine to check for leaks. Stop the engine. Recheck the oil
level and add oil if required. Refer to the engine owner's manual.
a
WARNING
Most used oil contains small amounts of materials that can cause cancer and other
health problems if inhaled, ingested, or left in contact with skin for prolonged
periods of time.
► Take steps to avoid inhaling or ingesting used engine oil.
► Wash skin thoroughly after exposure to used engine oil.
wc_tx000640gb.fm
b
WM 720
43
Maintenance
c
WM 650
d
d
wc_gr004396