Honda BF75D Manual page 34

2) With the throttle grip in the full open position,
check that the throttle arm is in contact with the full
open stopper of the shift link bracket.
THROTTLE ARM
FULL OPEN STOPPER
3) Holding the throttle grip in the position of the step
2, check the clearance between the throttle cam and
the stopper (full open side) of the throttle body. It
must be 1 mm or below.
THROTTLE
CAM
SHIFT LINK
BRACKET
STOPPER
(FULL OPEN SIDE)
1 mm max.
34
4) Move the throttle grip to the full close position.
Check that the throttle cam of the throttle body is in
contact with the stopper (full close side) securely.
5) Adjust if either the step 2, 3 or 4 is not satisfied (see
P. 34 or 35).
If the step 2 is not satisfied, go to the procedure of
<Throttle arm not in full open position>.
If either the step 3 or 4 is not satisfied, go to the
procedure of <Throttle cam not in full open
position> (See P. 35).
THROTTLE
CAM
<Throttle arm not in full open position>
1) Loosen the shift pivot lock nut of the remote control
cable (throttle side) and remove the shift pivot from
the throttle arm link pin.
LINK PIN
SHIFT PIVOT
LOCK NUT
STOPPER
(FULL CLOSE SIDE)
Must be in
contact securely.
THROTTLE ARM